3
  • thumbnail image 1
Print to PDF
[X]

Print recipe

NZ LOUSIE CAKE


Print:
4

Ingredients

NZ LOUSIE CAKE

BASE

  • 125 g Butter
  • 80 g caster sugar
  • 150 g plain flour
  • 1 level teaspoons baking powder
  • 1 egg yolk

Filling

  • 200 g Jam, Any flavour

Topping

  • 115 g caster sugar
  • 1 egg
  • 85 g Desiccated Coconut
  • 6
  • 7
    Preparation
  • 8
  • 9
5

Recipe's preparation

  1. Line the base and sides of an 18cm X 28cm slice tin with baking paper.

    Preheat the oven to 180 degrees celsius (fan-forced).

    Place the chopped butter, caster sugar, plain flour and baking powder into the Thermomix bowl and blitz for 10 seconds, Speed 7.

    Scrape down the sides of your bowl and add the egg yolk. Mix for 7 seconds, Speed 4 or until a soft dough forms.

    Press the dough into the base of the prepared slice tin.

    Use the back of a spoon to help spread the mixture out evenly.

    Place the tray into the oven and bake for approximately 13 - 15 minutes or until lightly golden brown.

    Allow the base to cool for 10 minutes before spreading the raspberry jam over the top.

    To make the topping, place the caster sugar, egg and coconut into your Thermomix bowl and mix for 20 seconds, Speed 2, or until combined.

    Spread the topping over the raspberry jam and bake the slice for a further 25 minutes or until the coconut is lightly golden brown.

    Remove the slice from the oven and allow it cool completely in the tin before cutting into pieces.
10

Accessories you need

  • Spatula TM5/TM6
    Spatula TM5/TM6
    buy now
11

This recipe was provided to you by a Thermomix ® customer and has not been tested by Vorwerk Thermomix ® or The Mix Australia Pty Ltd and The Mix New Zealand Ltd.
Vorwerk Thermomix ® and The Mix Australia Pty Ltd and The Mix New Zealand Ltd assume no liability, particularly in terms of ingredient quantities used and success of the recipes.
Please observe the safety instructions in the Thermomix ® instruction manual at all times.

Other users also liked...


Comments

Add a comment
  • There are no comments at the moment.